Overview
The IP8-MOUNT kit fixes an IP8 remote controller into a wall, plinth, podium or piece of furniture. The IP8 slides into the bracket and is held with six screws through its threaded inserts, and the bracket fixes to the structure through four corner holes. It makes an IP8 a permanent part of a room, safe from being knocked off a table.
Highlights
- Fits the IP8 remote controller
- Wall aperture minimum 280 x 205 mm, 60 mm deep
- Bracket plus six 6AB x 3/8 Pozi screws included
- Wall fixings not supplied
Compatibility
Works with: Allen & Heath IP8 only. For the IP6, ME-1 or ME-500 use the IP6-ME-MOUNT kit.
Specifications
| Fits | IP8 |
| Wall aperture | 280 x 205 mm minimum, 60 mm depth |
| Includes | Wall bracket, 6 x 6AB x 3/8 Pozi screws |
| Wall fixings | Not included |
| Fitting note | A&H AP12038 |
Forefront Tip
Run the Cat6 to the top of the aperture with a service loop so you can slide the IP8 out of the bracket for maintenance without pulling the cable.
Forefront Productions in Newcastle NSW is an authorised Allen & Heath dealer. We send orders Australia wide and are happy to check your system design before you buy.
